Hydraulic System; Fuel And Evaporative Emissions Control System - HUSTLER X-ONE Manual De Instrucciones

noid which is mounted on the left front of the engine.
Figure 4-1
CZ
DA
DE
EN
A. Master fuse housing

Hydraulic System

IMPORTANT: Refer to the General Service Manual (P/N
ES
123499) for complete hydraulic oil and filter change proce-
dures.
IMPORTANT: Never use hydraulic or automatic transmis-
sion fluid in this system; use only specified oil. Remember,
dirt is the primary enemy of any hydraulic system. Check oil
FR
level in hydraulic system after every 50 hours of operation or
weekly, whichever occurs first. Check more often if system
appears to be leaking or otherwise malfunctioning.
When checking the hydraulic system's oil level:
1. Always check oil level with the mower on level ground.
IT
2. Always check oil level when the oil is cold (mower has
not run for at least 1.5 hours).
3. Always check oil level with the dipstick installed and
tightened.
IMPORTANT: Full level when oil is cold is anywhere on
the dipstick, up to the "H" line. Oil must not be above
NL
the "H" (High mark). Figure 4-2
Change hydraulic system filter element and oil after first
750 hours of mower operation, then replace filter and oil in
reservoir every 500 hours thereafter.
The following is a list of the oils that are approved for use
PT
in the Hustler X-ONE
®
A. Parker HT-1000 (replace after every 750 hours)
B. Castrol Edge 5W-50
C. Shell Rotella T6 5W-40
SV D. Lucas – Magnum High TBN CI-4 15W40
E. Amsoil AW ISO 68
REV B
A
Figure 4-1
hydraulic system.
®
A
B
A. Dipstick
IMPORTANT: Use only the approved oils listed above. Use
of any unapproved oils will void your warranty.
The Hustler X-ONE system filter is located at the bottom
® ®
of the integrated transmission with access to it from the
front. (Figure 4-3) Use a Hustler
When changing the filter use a 3/4" hex wrench. The threads
are right hand.

Fuel and Evaporative Emissions Control System

IMPORTANT: Refer to the Safety section of this manual for
fuel handling safety information.
Use only Hustler approved replacement parts.
®
Your evaporative emission control system may include
parts such as:
• fuel tanks
• fuel lines
• fuel line fittings
• fuel caps
• carbon canisters
• canister mounting brackets
• carburetor purge port connection
• filters
• vapor hoses
• clamps, control valves
• control solenoids
• electronic controls
• vacuum control diaphragms
4-2
B. "H" mark
Figure 4-2
approved filter element only.
®
606528CE