Seat Adjustment - HUSTLER X-ONE Manual De Instrucciones

Comparison of Warped and Straight Blades
CZ
DA
A. Warped blade — replace
B. Straight blade
DE
C. Cutting plane
End view of blades, comparing twisted and straightened
blades.
EN
D
A
C
ES
D
FR
A. Twisted blade edge —
replace blade
B. Straight blade edge
IT
Mower Blade Replacement
IMPORTANT: Refer to the Safety section of this manual for
blade handling safety information.
NL
Mower blades are sharp and can cut. Wrap the
blade(s) or wear gloves and use extra caution
when servicing them.
PT
A 15/16" wrench is required to remove the 5/8" cap screw
holding the blade to the spindle shaft. NOTE: A blade holding
tool (P/N 381442) is available from Hustler
It is designed to prevent the blades from rotating when they
SV
REV B
A
B
Figure 4-14
B
C. Cutting plane
D. Cutting edge
Figure 4-15
Turf Equipment.
®
are being removed or installed on the spindle. Contact your
Hustler Dealer for more information.
®
Do not re-use spindle bolts which have stripped, worn or
undercut threads. Torque bolts on spindles to 160.0 N•m
when reinstalling blades.
C
Failure to correctly torque the bolt may result in
the loss of the blade which can cause serious
injury.
Properly compressed cup washers maintain the correct
compression load on the blades. Replace the cup washers if
they are cracked or flattened.
IMPORTANT: The blade sail (curved part) must be point-
ing upward toward the inside of the deck to ensure proper
cutting.
When mounting blades, rotate them after installation to
ensure blade tips do not touch each other or sides of the
mower.
Mower Blade Options
The following is a list of the approved mower blade options
that are available from Hustler
mower.
Use only genuine Hustler
ensure that original standards are maintained.
Failure to use approved blades could lead to blade
breakage which could result in death, injury or
property damage.
787721
794198
785436
601124
797704
797712

Seat Adjustment

IMPORTANT: Any maintenance operation that requires
the removal of safety covers must be performed by a trained
service technician.
The seat on the mower can be adjusted forward and rear-
ward by sliding the seat release lever until a comfortable
operating position is attained.
4-8
Turf Equipment for this
®
replacement blades to
®
52" Side Discharge Deck
BLADE, F17.86"-H-F-CW
BLADE, 17.86"-MUL-F-CW
BLADE, 17.86"-GAT-F-CW
54" Rear Discharge Deck
BLADE, F18.50"-L-F-CW
BLADE, 18.50"-MUL-F-CW
BLADE, 18.50"-GAT-F-CW
606528CE