Troubleshooting - HUSTLER X-ONE Manual De Instrucciones

The majority of operating problems that occur with a system can be traced to improper adjustments or delayed service. A
consistently applied preventative maintenance program, as outlined in the Maintenance section of this manual, will prevent many
problems. The following chart is designed to help you locate a problem by suggesting probable causes and the recommended
solutions.
SYMPTOMS PROBABLE CAUSES
Starting motor does not Steering control levers not
crank in park brake position or
switch not adjusted
Deck clutch switch
engaged
Weak or dead battery
Electrical connections are
corroded or loose
Fuse is blown
For additional causes
The engine will not start, No fuel or line plugged
starts hard or fails to
keep running
Fuel valve is turned off
There is incorrect fuel in
the fuel system
There is dirt in the fuel filter
Dirt, water or stale fuel in
the fuel system
The choke (if equipped) is
not on
Numerous
Engine: Numerous
Runs with continuous
misfiring or engine runs
unevenly or erratically
Loss of power or system Restrictions in air cleaner
will not operate in either
direction
Internal interference or
leakage in transaxle
Poor compression
Steering linkage needs
adjustment
Tow valve open
The traction drive belt is
worn, loose or broken
Air in system
For additional causes
Low engine oil pressure Low oil level
Oil diluted or too light
Failed oil pump
High oil consumption Numerous
606528CE

TROUBLESHOOTING

SUGGESTED
REMEDIES
Mower jerky when start-
Place steering control ing or operates in one
levers in park brake posi- direction only
tion or re-adjust switch
Disengage clutch switch
Recharge or replace
Check the electrical con-
nections
Mower creeps when
steering control levers are
Check fuses – replace in neutral
blown fuse
Mower circles or veers in
See engine manual one direction
Fill tank or replace line
(See Fuel System section
for more details)
Open the fuel valve
Drain the tank and replace
the fuel with the proper
type
Mower creeps when park-
ing brake engaged
Replace the fuel filter
Contact your dealer
There is abnormal vibra-
tion
Move the choke lever to ON
See engine manual
See engine manual
Service air cleaner
See your dealer
See your dealer
Adjust linkage
Blades do not rotate
Close tow valve
Install a new traction drive
belt
Check filter and fittings
See engine manual
Add oil
Change oil and check for
source of contamination
Contact your dealer
Contact your dealer
5-1
SYMPTOMS PROBABLE CAUSES
Steering control linkage
needs adjustment
Transaxle component
faulty
Tow valves not closed
completely
Loose steering linkage
Steering linkage needs
adjustment
Steering linkage needs
adjustment
Loose steering linkage
Tires improperly inflated
Transaxle component
faulty
Steering linkage out of
adjustment
Brakes need adjustment
The engine mounting bolts
are loose
The engine pulley, idler pul-
ley or blade pulley is loose
The engine pulley is dam-
aged
The cutting blade(s) is/are
bent or unbalanced
A blade mounting bolt is
loose
Spindle bearing is worn or
loose
A blade spindle is bent
The deck drive belt is worn,
loose or broken
The deck drive belt is off
the pulley
Electric clutch is not
engaging
CZ
SUGGESTED
DA
REMEDIES
Adjust linkage
Contact your dealer
Close tow valves
DE
Tighten linkage
Adjust linkage
Adjust linkage
EN
Tighten linkage
Adjust air pressure to 55–
83 KPa
Contact your dealer
ES
Adjust steering linkage
Adjust parking brakes
Tighten the engine mount-
ing bolts
Tighten the appropriate
FR
pulley
Contact your dealer
Install new cutting blade(s)
Tighten the blade mount-
IT
ing bolt
Replace or tighten spindle
bearing
Contact your dealer
Install a new deck drive
belt
NL
Install the deck drive belt
and check for a reason
Check and/or replace 10
amp fuse.
Contact your dealer
PT
SV
REV B