Indel B K BASIC Serie Instrucciones Para El Uso página 23

IN S TALL ATIO N
To install the Minibar properly, you must ensure the air supply to the refrigerating unit making
openings for air inlet and outlet as shown on the following figure.
VE NTIL ATIO N
The compressor cooling system lets out heat and needs good ventilation. Therefore places with
bad ventilation are not very suitable. The Minibar must be installed in a place with an opening
which guarantees the necessary exchange of air, and it is of the utmost importance not to
cover up or obstruct the grids which provide the device with proper ventilation. One must also
avoid positioning it in a place which is directly exposed to sunlight or to other heat sources.
For built-in models, you must fit the Minibar into
the cabinet, guaranteeing a cross section at the
air inlet and outlet of at least 200 cm
ding to a height of 48 mm along the entire width of
the refrigerator.Leave a space of 60 mm between
the top and sides of the Minibar and the cabinet.
21
, correspon-
2