Installing The Operator - Erreka VULCAN S Manual Del Instalador

INSTALLATION
3

INSTALLING THE OPERATOR


Horizontality of the operator
O
The operator must work horizontally: to do
this, the supports must be positioned with a
height difference of 19 mm.

Assembly positions and dimensions

For the correct operation of the operator, it is
essential that the supports are positioned respecting
the dimensions calculated, with regards to the gate
and its rotation axis.

The dimensions are selected using either the table or
the attached chart. The table indicates some specific
cases, whilst the chart shows all the possible cases.
44
Installation manual

Check horizontality using a Spirit level.
The assembly dimensions depend on the opening angle
of the gate and the following factors:
• Type of operator chosen: short (Piston rod travel =
265mm) or long (Piston rod travel = 400mm)
• Opening of the gate inward or outward.
Hence there are four different cases, as explained below
(each case is represented by way of its corresponding
diagram, table and chart).