AERMEC GLLI10N Manual De Uso página 30

DISPLAY CARD OPERATION
The thermostat can be coupled to a
display card which must meet the
following requirements:
• LED Interface to view the operating
status of the fan coil (operating mode,
COMMANDS START PROCEDURE, FROM AUX KEY
AUTOTEST
LED
DISPLAY
ALARMS LOG
To exit the test/correction functions an ON/OFF command (via VMF-E4 panel) or a change mode command (AUTO, V1, V2,
V3, AUX) must be given to the cassette.
30
AGLLI10/20NFJ 07/11_4528572_00
alarms, probe read-code)
• Starting point of the special commands
such as: correction of the probe reading,
display of the data read by the probes,
display of the alarm log, start of the
Autotest procedure
Yellow/Green LED
AUX
V3
OFF
AUTO
V1
V2
CORRECTION
S.A.
KEY
The new display card must have a layout
as shown in the following figures:
AUX key
Blue/Red LED
AUTOTEST
PROBE
READING
Pressing MODE/SELECT key
(see VMF-E4)
Pressing AUX key
Pressing OFF or MODE/SELECT
key (see VMF-E4)