AERMEC GLLI10N Manual De Uso página 31

AUTOTEST
The activation of the ventilation and the
valve of the branch corresponding to
the operating season, even in unsuitable
water or environment temperature
Pressing
Autotest
AUX key
PROBE READING
Values of the temperature probes
acquired by the electronic card can be
viewed through the yellow and red LED.
In this mode the card enters in the Probe
ALARMS LOG
The receiver cyclically indicates the last
5 alarms occurred on the machine in the
"alarms log" view mode:
ALARM
conditions, can be "forced" in the self-
test mode so as to verify the correct
functioning of the connections and the
windings of the electric motor.
V1
of the
ON
Pressing
MODE
SELECT
Display mode. Initially the card displays
the value of the Ambient probe SA.
Press the AUX key normally to view
other probes. The number of flashes by
Green LED
2
3
4
5
• yellow LED: cyclically flashes 5 times,
and then remains off for 5 seconds
Pressing
V2
of the
ON
AUX key
Autotest Off
Probe displayed
SW probe
Aux SW probe
SA probe
Resistor probe SR
VISUALISATION
No alarm
Air probe faulty
Anti-freeze
Insufficient water
E4 interface not connected
Inverter fault
Resistor fault
condensate discharge
Motor fuse
Non-encoded signals
AGLLI10/20NFJ 07/11_4528572_00
Pressing
of the
AUX key
Pressing
the green LED indicates which probe is
displayed (see table).
• red LED: lights at the same time as the
yellow LED thereby providing a specific
code
Key
V3
ON
MODE
SELECT
Yellow LED
Red LED
31