Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Take the unit out of its box and
make sure that all of the pieces are
there Fig.1:
(1)
Main body.
(7)
Handlebar.
(6)
Handlebar stem.
(4)
Saddle post.
(5)
Horizontal saddle tube.
(21) Saddle.
(3)
Rear
stabiliser
adjustable feet.
(2)
Front stabiliser bar with wheels.
(23L) Left pedal.
(23R) Right pedal.
(M)
Monitor casing and components.
(8)
Slot head bolt M-10x65.
(9)
Flat washer M-10.
(10) Cap nut M-10.
(20) Knob.
(59) Screws M-8x20.
(60) Spring washer M-8.
(61) Flat washer M-8.
(62) Head caps.
(75) Screws 3x15.
2.
Position the front stabiliser bar with
wheels (2), paying attention to the red
dots and with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (8), fit the flat washers (9) cap
nuts (10) and tighten securely.
3.
Position the machine's rear stand
on the rear stabiliser bar (3), as shown
in Fig.3, insert the bolts (8), fit the flat
washers (9) cap nuts (10) and then
tighten securely.
4.-MOUNTING THE
HANDLEBAR.-
Bring handlebar tube (6) close to main
body (1) Fig.4. Connect terminal (71)
coming out of the main frame (1) to
terminal (67) coming out of the
handlebar tube (6) Fig.4.
By slightly unscrewing knob (16) Fig.4
(a few turns in an anti-clockwise
direction) and pulling it outwards
without releasing it, insert handlebar
tube (6) in the projection on main
frame (1). Fig.4. Release handle (16)
and insert it in one of the holes on the
handlebar tube.
Insert handlebar (7) in handlebar tube
(6), Fig.4, insert screws (59) together
bar
with
with spring washers (60) and flat
washers (61). Move the handlebar to a
comfortable position and firmly tighten
the screws.
ADJUSTING THE HANDLEBAR
VERTICALLY.
Position
comfortable distance for doing exercise,
now tighten knob (16-58) securely,
Fig.5. Stay within the references.
5.- ATTACHING THE MONITOR.-
Position the bracket (65) on the
handlebar (7), insert the screw (75),
as shown in Fig.6, and tighten the
screw (75).
Place the monitor (66) and the bracket
(65), as shown in Fig.6, Connect
terminal (67) of the middle Fig.6
6.- ATTACHING THE SADDLE.-
Fit the saddle bracket (21), Fig.7, onto
the horizontal saddle tube (5), as
shown in Fig.7, fit the saddle into
position and tighten the nuts on the
bracket securely.
Next insert the horizontal saddle tube
(5) through the hole on the saddle
post (4), Fig.7, position it correctly and
tighten the knob (20), Fig.7. Insert the
saddle post (4) into the boss on the
main body (1), position it correctly and
tighten the saddle post by using the
adjustment knob (16), Fig.7, turning it
clockwise.
11
the
handlebar
(7)
at
a
Publicidad
