TOHATSU MFS 40A Manual Del Propietário página 35

Remedy
1.
Reduce the throttle to less than half
opening, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
aged blades.
Consult an authorize d de aler if
engine shows the same result even
after replacing propeller with new
one.
2.
Move to safe place quickly, and stop
the engine.
Check the engine oil level, and add
engine oil if necessary.
Consult your dealer if the engine oil
level is too low or too high.
3.
Move to safe place quickly, and
check the discharge of cooling water
from the water check port at idle
speed and stop engine.
Remove any foreign matter on the
gear case and propeller if necessary.
Consult an authorized dealer if no
discharge of cooling water.
4.
Charge or replace the battery.
5.
Consult an authorized dealer.
6.
Replace the engine oil (See page 68)
and reset the indicator (See page 33).
ENOW00025-A
CAUTION
Low speed ESG ON: Engine speed will be
limited to 2800 min
should not continue to run engine.
High speed ESG ON: Engine speed will be
limited to 6200 min
will run rough until throttle is reduced.
-1
(rpm), however you
-1
(rpm) and engine
PRE-OPERATING PREPARATIONS
ENOM00870-0
Engine oil replacement indicator
function reset method
As for "Engine oil replacement indicator
function", informing the appropriate
timing of engine oil replacement by
blinking of the lamp, when beyond 100
hours operating.
1. Be certain the safety lanyard is
installed. Turn the key to the 'on'
position and after the 'beep' pull the
safety lanyard off.
2. Within 5-10 seconds, Pull the red
knob on the safety switch out and
release.
3. Wait 5-10 seconds and pull the red
knob out and release.
33
1 Second
ENOF00853-0
ENOF00854-0
ENOF00854-0
6