Maintenance - John Bean EHP System IV-E Manual Del Operador

5
6
7
C
A
24-EN
6.0-1
6.0-2
8
b
6.0-3

6.0 maintenance

WARNING
bEFORE ATTEMPING ANY MAINTENANCE OR
REPAIRS THE MACHINE MUST bE DISCONNECTED
FROM THE AIR AND ElECTRIC SUPPlY.
A. Periodically clean the vertical hexagonal rod with
nonflammable liquid detergent. Lubricate with oil (Fig.
5.4).
b. Periodically clean all moving metal parts and
lubricate with oil.
C. Clean the teeth of the clamps with a wire brush,
check the plastic rim protectors and replace if worn
(Fig. 5.5).
D. Peridically replaced the plastic insert inside mount/
demount tool.
E. Lubricate rods of air cylinders with oil as needed.
F. Periodically wash all plastic parts with cold water
and soap or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge the water every day from air filter. Do this
by pulling down the fitting 'b' (Fig. 6.0-3).
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly.
When adding oil to the lubricator, disconnect the air
supply first, remove the cup 'A', and add oil as needed.
Make sure seals are in place when repositioning the
cup
l. Check oil dosage: After operating the pedals (6 and
7, Fig. 6.0-3) 2 - 3 times, one drop of oil should fall into
the sight glass. If necessary adjust using the dosing
screw (C, Fig. 6.0-3).
WARNING! PAY ATTENTION TO KEEP FILLED
THE OIL TANK OF THE OILER, EXPECIALLY FOR
AIR MOTOR OPERATED MACHINES.
WARNING! USE ONLY OILS FOR AIR DEVICES,
DO NOT USE BRAKE FLUID OR OTHER NOT
SUGGESTED LUBRICANTS.
Suggested oils for the filter/lubricator unit:
TAMOIL: WHITE MINERAL OIL 15
SHELL: ONDINA OIL 15
BP: ENERGOL WT 3
TOTAL: LOBELIA SB 15
ESSO: MARCOL 82