Wheel Spin Counter; Wheel Spin - Corghi LaserLine EM 9550 Manual De Uso

- Press the button to change the setting;
the threshold is eliminated and the
icon is indicated on the status line on the LCD
display.
- Press the button to confirm selection
and exit the programme menu.
Rounding off temporarily
Perform the following procedure to display the
unbalance values from grx5 to grx1 (from oz/4 to
oz/10) temporarily:
- keep the button pressed in all bal-
ancing environments except for ALUP.
Warning:
if the unbalance visualisation is in grX1, the
button is not active.

WHEEL SPIN COUNTER

Perform the following procedure to display the
number of wheel spins performed:
- Press the button to access the pro-
gramme menu.
- Use the
cursor.
- Select the programme icon.
- Press the button to display the total
number of wheel spins performed by the machine
since its first start-up.
- Press the button to display the partial
number of wheel spins performed since the last
machine switch-on (it is reset to zero every
time the machine is switched off).
- Press the button to display the num-
ber of wheel spins performed since the last
EM 9550 - Operator's manual
buttons to move the
sensitivity calibration (it is reset to zero every
time a calibration procedure is performed).
- Press the button to exit.

WHEEL SPIN

Wheel spins take place automatically by lower-
ing the guard or pressing the
with the guard lowered.
A special safety device stops rotation if the guard
is raised during the spin; in this case, the "A Cr"
message is displayed.
During position search, the wheel can rotate with
the guard raised.
WARNING
Do not operate the machine without the guard
and/or if the safety device has been tampered
with.
WARNING
Never raise the guard before the wheel has
come to a stop.
WARNING
If the wheel keeps spinning permanently due to
a fault on the machine, switch off the machine
using the main switch or disconnect the plug
from the power supply board (emergency stop)
and wait until the wheel stops before raising
the guard.
button
UK
57