Final Operations - Carel huniDisk Serie Manual Del Usuario

Fig. 2.w
Water connections on the humiDisk
E D
Water connections on the humiDisk

2.8 Final operations

Make sure that all the wires are positioned properly inside the appliance as shown in Figs 2.t and 2.u.
For the humiDisk check that the junction box is properly closed and positioned correctly, and that the
65
spring is tightened. The box must have the surface of the cover resting on the two surface locators, as
shown in Fig. 2.w.
• Replace the air fi lter and tighten the three supporting screws;
• adjust the direction of the outlets. To do this, loosen the screws that hold the diffuser on top of the
appliance; see position 1 in Fig. 1.a for humiDisk
of the operation tighten the screw again.
• check that the water connections have been carried out correctly. Open the water supply tap and check
that there are no leaks along the supply circuit.
14
10
10°
<
A
Fig. 2.v
65
Fig. 2.z
and position 5 in Fig. 1.b for humiDisk
10
humiDisk - +030222022 - rel. 2.1 - 01.03.2012
C B
: at the end
65