Humidistat Dn33Z9Hr20 On Electrical Panels Ucq065D100 And Ucq065D200 - Carel huniDisk Serie Manual Del Usuario

9. HUMIDISTAT DN33Z9HR20 ON ELECTRICAL PANELS
1
2
3
R
4
4 1 2 3
Fig. 9.a
OUTPUT 1
ON
OFF
(P3)
differenziale (P1) zona neutra
differential (P1) dead zone
Fig. 9.b
UCQ065D100 AND UCQ065D200
humiDisk can be managed by an electrical panel (code UCQ065D100; UCQ065D2000) featuring the
65
DN33Z9HR20 microprocessor electronic controller. The controller has ON/OFF operation and can con-
stantly display the humidity value read by the probe; in addition, a remote ON/OFF contact and an alarm
output are available.
Key:
1. Display: shows the value of the probe connected. In the event of alarms, the value read by the probe is displayed
alternating with the code/codes of the active alarms. When programming, shows the codes of the parameters
6
and their values.
5
2. Decimal LED
7
3. Reverse symbol: it is ON when humidifi cation mode is active;
8 4. Output active;
5. Set button: used to display and/or set the set point. If pressed together with the Prg button for 5 seconds, the user
can enter the password and access the confi guration parameters (parameters with code types "Cxx").
6. Prg/mute button: pressed for 5 seconds, accesses the menu of the most frequent parameters (code type "Pxx").
If there are active alarms, mutes the buzzer. Resets the other alarm signals if pressed when the causes are no
longer present;
7. button: increases the value of the set point or any other parameter selected;
8. button: decreases the value of the set point or any other parameter selected.
The graph to the side shows the operating modes of the controller.
Table of default parameter values:
parameter
relative humidity set point
relative humidity differential
dead zone
low humidity alarm
high humidity alarm
alarm differential
alarm delay
operating mode
delay between the activation of two different relays
management of digital input 1
special operation
dependence
type of output
activation
differential/logic
dependence
dependence
type of output
activation
differential/logic
dependence
type of output
activation
differential/logic
24
code Default values
St1 50% RH
P1 5.0% RH
P3 0% RH
P25 0.0% RH
P26 99.9% RH
P27 2.0% RH
P28 60
C0 2
C6 5
C29 4
C33 1
C34 1
C35 0
C36 -100
C37 +100
C38 3
C42 1
C43 0
C44 -100
C45 +100
C46 1
C47 0
C48 -100
C49 +100
humiDisk - +030222022 - rel. 2.1 - 01.03.2012
Tab. 9.a