User Control Menu; User Config Menu - Sony Trinitron PVM-9L3 Manual De Instrucciones

USER CONTROL menu

The USER CONTROL menu is used for adjusting the
picture.
Items that cannot be adjusted depending on the input
signal are displayed in blue.
Submenu Setting
AUTO CHROMA/ Adjusts color intensity (CHROMA)
PHASE and tones (PHASE).
• AUTO ADJ VALUE: Chooses
• START: Displays the color bar
Note
If you have selected full color bars,
be sure to enter eight color bars.
SUB CONTROL You can finely adjust the
adjustment range of the following
controls on the control panel; the
CONTRAST, PHASE, CHROMA
and BRIGHT controls.
• ADJUST...: adjusts the
the values to be applied to
the chroma and phase from
auto adjustment or factory
settings.
ON: auto adjustment values
OFF: factory preset values
signals (Full/SMPTE/EIA)
on the screen. To select one,
press ENTER/SELECT
button. The auto adjustment
function starts. After the
adjustment has been done
correctly, AUTO ADJ
VALUE is automatically set
to ON. Press the MENU/
EXIT button to exit the
adjustment screen.
following items.
CONTRAST...: Adjusts the
picture contrast.
BRIGHT...: Adjusts the picture
brightness.
CHROMA...: Adjusts the color
intensity. The higher the
setting, the greater the
intensity.
The lower the setting, the
lower the intensity.
PHASE...: Adjusts color tones.
The higher the setting, the
more greenish the picture
becomes.
The lower the setting, the
more purplish the picture
becomes.
APERTURE...: Adjusts the
picture sharpness. The higher
the setting, the sharper the
picture.

USER CONFIG menu

The USER CONFIG menu is used to select a language for
the menus and the on-screen messages or to determine the
type of video signal acceptable on the RGB/
COMPONENT connectors (Analog RGB or component).
Submenu Setting
RGB/COMP SEL According to the type of video
(for the PVM-14L2/ signal which you intend to input to
PVM-20L2 only) the RGB/COMPONENT
connectors, choose between RGB
and COMPONENT.
COMP LEVEL Select the component level from
among three modes.
SMPTE: 100/0/100/0 signal
BETA 7.5: 100/7.5/75/7.5 signal
BETA 0: 100/0/75/0 signal
NTSC SETUP Select the NTSC setup level from
two modes.
The 7.5 setup level is used mainly
in North America. The 0 setup level
is used mainly in Japan.
FORMAT DISP Determines whether the format of a
input signal is displayed on the
screen or not.
ON: The format is always
OFF: The format is always
AUTO: The format is displayed
LANGUAGE You can select the desired language
for the menus or messages from the
following language options.
ENGLISH: English
DEUTSCH: German
FRANÇAIS: French
ITALIANO: Italian
ESPAÑOL: Spanish
DEGAUSS DELAY Sets the delay time for auto
degaussing to start working after
the power is turned on. The delay
time can be set within 0 to 99
seconds.
CAPTION Selects the caption display mode
(available only when the from among the following options:
Caption Vision (Closed OFF, CAPTION 1, CAPTION 2,
Caption) Decoder has TEXT 1 and TEXT 2.
been installed.)
displayed.
hidden.
for about 10 seconds when the
input of the signal begins.
: Japanese
: Chinese
Adjustment Using the Menus
29