Nuova Simonelli Aurelia II 2 GR S Libro De Instrucciones Para El Usuario página 48

The maximum and minimum storage
temperatures must fall within a range
of [-5, +50]°C.
The operating temperature must be
within the range of [+5, +35]°C.
At the end of installation, the device is
switched on and taken to rated operat-
ing conditions, leaving it in a state in
which it is "ready for operation".
The device is then switched off and the
whole hydraulic circuit is bled of the
first lot of water in order to remove any
initial impurities.
The device is then refilled and taken to
rated operating conditions.
After reaching the "ready for opera-
tion" condition, the following dispens-
ing operations are carried out:
- 100% of the coffee circuit through
the coffee dispenser (for more than one
dispenser, this is divided equally);
- 100% of the hot water circuit through
the water dispenser (for more than one
dispenser, this is divided equally);
- opening of each steam outlet for 1
minute.
At the end of installation, it is good
practice to draw up a report of the
operations.
Basic rules must be observed when
using any electric appliance.
In particular:
do not touch the appliance when
hands or feet are wet;
do not use the appliance when
barefoot;
CAUTION
RISK OF ELECTRIC SHOCK
50
do not use the appliance when
barefoot;
do not pull the supply cord out of
the socket to disconnect it from
the mains;
do not leave the appliance
exposed to atmospheric agents
(rain, sun, etc.);
do not let the appliance be used
by children, unauthorised staff or
staff who have not read and fully
understood the contents of this
handbook.
During installation, the mains power
system needs to be equipped with a
disconnector switch to cut off each
phase.
Before performing any maintenance
operations, the authorised service
engineer must switch off the machine
and open the phase disconnector.
For all cleaning operations comply
exclusively with the instructions
given in this booklet.
If the appliance breaks down or fails
to work properly, switch it off. Any
intervention is strictly forbidden.
Repairs should only be made by the
manufacturer or authorized service
centres.
Only original spare parts must be
used.
Failure to observe the above, could
make the appliance unsafe.
For installation, the qualified electri-
cian must fit an omnipolar switch in
accordance with the safety regula-
tions in force and with 3 (0,12) or
more mm (in) between contacts.
To avoid dangerous overheating,
make sure the supply cord is fully
uncoiled.
Do not obstruct the extraction and/or
dissipator grids, especially of the
cup warmer.
The user must not replace the appli-
ance supply cord. If the cord is dam-
aged, switch off the appliance and
have a qualified technician change
the cord.
Single-phase appliances with current
above 15 A and three-phase appli-
ances sold without plugs are directly
wired to the mains power and there-
Fig. 5
fore, it is not possible to use a plug.