Programming Aurelia S - Nuova Simonelli Aurelia II 2 GR S Libro De Instrucciones Para El Usuario

Pressing the one long coffee, will start
the washing cycle for the relevant unit. After
the washing cycle, it is possible to carry out
a rinse cycle on the same group, by pressing
the key, one long coffee again.
If you want make the rinsing cycle in an other
time it's enough to switch off the machine:
the control board memorizes the cleaning
cycles that you must end.
At the next switch on, in fact, the card will
automatically enter the unit washing state
without pressing the
long coffee keys.
Holding down the key for 2 seconds
will quit the washing state if there are no
cycles to complete; otherwise the
long coffee keys on the units still needing a
rinse cycle.
Holding down the key for 2 seconds
more will force quitting of the washing state,
resetting the information about rinse cycles
still to be completed.
If the washing cycle is completed, the
one long coffee key for the unit will switch off
and if there are no more rinse cycles to be
completed, the card will quit the washing state.
7.5 PROGRAMMING
AURELIA S
DOSE PROGRAMMING
In the Aurelia S version only the doses of water
and timed steam can be programmed.
To access the programming state you must:
Hold down the hot water key for five
seconds.
HOT WATER
Once in the programming state, pressing the
hot water key will activate hot water
delivery; once at the required dose, press the
hot water key again and the control
unit will memorise the set delivery time.
NOTE: Press the
gramming function.
and one
TIMED STEAM
Once in programming mode, pressing the
one
steam key will activate steam deliv-
ery; once at the required amount, press the
steam key again and the control unit
will memorize the set delivery time.
NOTE: Press the
gramming function.
ADJUSTING LIGHTING INTENSITY
KEYBOARD
Access programming according to the rela-
tive procedure.
Adjust the light intensity of the keys by
pressing the first unit's 1 long coffee
key more than once.
NOTE: To exit programming press the
key.
PUMP ACTIVATION
IN THE SELF-LEVELLING STAGE
To set pump activation during the self-level
stage, after first entering the programming
mode, hold down the
unit.
The
on and pressing the
will show the pump setting: if on, the pump
key to quit the pro-
will operate during levelling; if off, the pump
will not operate during self-levelling.
Pressing the
possible to change the setting for the pump
during levelling.
NOTE: Press the
WATER DOSE AND
STANDARD STEAM PROGRAMMING
key to quit the pro-
It is possible to enter preset values for steam
and water. Proceed as follows:
Press and hold down the
for at least 8 seconds, until the flashing keys
switch off.
The standard doses are shown in the table
below:
NOTE: A time of 0 seconds for steam means it
key of the second
key of the second unit will switch
key of the first unit
key of the first unit, it is
key to quit the program-
ming function.
hot water key
9 sec. 0 sec.
will function in continuous mode.
73