Care And Maintenance - Steinbach Poolrunner Battery Basic Manual De Instrucciones

Setting the wheels
You can adjust the operating radius by setting the wheels (fi gures 12 & 13).
To do this, push the wheel clasp (1) away from the support and detach the
wheel (2). The following settings are recommended:
Setting 1: Standard setting: B-C, for most pools
Wheel angle
Travel path
Setting 2: C-C, for large pools
Wheel angle
Travel path
Setting 3: B-A, for small pools
Wheel angle
Travel path
Caution: These are recommended settings. Other settings may work
better for your pool.
Installing the brush
Press and install the brush into the
1
notch provided
Make sure that the brush is pro-
2
per-ly held in place.
Rmoving the brush
Push the brush strips out from
1
inside the robot
2 Remove the brush.
Start-up
Please make sure that the pool cleaner is switched off before charging.
In order to charge the battery, connect the robot to the power cable via the
charging adapter. The robot must not be placed overhead during charging.
The red light on the charger indicates that the battery is charging. The light
turns green when charging is complete.
After you have adjusted the settings, lower the cleaner carefully and slowly
in the pool. Make sure that the cleaner is completely immersed and that
all air has been released before switching it on. Not doing so impairs its
proper operation. Please observe the following fi gures on how best to lower
the cleaner into the pool. Figures 4
Press the power button on the bottom after placing it in the water. The
cleaner is automatically activated and starts to operate about 15 seconds
later.
The robot turns automatically as soon as it comes into contact with the pool
wall (in pools with curved fl oors it rises and falls backwards).
Switching the robot off:
The pool robot ends cleaning automatically when the battery is completely
empty (after approx. 60 minutes) and switches off automatically. If the pool
robot stops for a short time due to the shape of your pool, but the motor is
still working, you can correct this with the supplied leash. Press the button
on the bottom again to switch off the cleaner. Always clean the fi lter after
use.

Care and maintenance

Cleaning the fi lter, fi gures 6, 7, 8, 9, 10, 11
Hints and tips
Status
Switching on
Switching off
The cleaner is out of the water.
Operating cycle complete
■ Every time the cleaner is taken out of the water, the fi lter element must
be cleaned.
■ The pH level of the water in the pool must be between 7.0 and 7.4.
■ The water temperature must be between 18°C and 35°C.
■ We recommend keeping the cleaner between 5°C and 40°C in a well
ventilated place out of direct sunlight. Avoid direct sunlight at all times.
■ The two small brushes are a support device for improved cleaning. If your
pool fl oor is not completely plane, do not install the brushes or remove
them if you have already installed them to avoid jamming at a corner or
uneven fl oor.
061205_v1911 EN
Indicator
The cleaner beeps when it is
switched on out of the water. The
beeping stops as soon as it is
immersed in the water.
The beeping stops when the pool
cleaner is switched off out of the
water.
Pool cleaner beeps
Pool robot stops
9