Medela Symphony Manual De Instrucciones página 14

Troubleshooting
XII
If the motor is
not running
If there is low
or no suction
If there is an
overflow
14 EN
Check
• mains/battery power is present
• the device is switched on
• program card is inserted at the back of the breastpump
Make sure
• the breastshield forms a complete seal around the breast.
• all connections of the kit and breastpump are secure.
• the white valve membrane is laying flat against the yellow valve
head. Check that the valve head and membrane are clean and
not damaged. See «Assembly Instructions».
• the ends of the tubing are fit securely into the back of the
breastshield and into the opening on membrane cap.
• the protective membrane / membrane cap are correctly
assembled and are pushed firmly into place on breastpump
diaphragm.
• the protective membrane is intact.
Take care not to kink or pinch tubing.
If milk accidentally gets into the tubing
• Turn off the pump and unplug from power source.
• Use a damp (not wet) cloth to wipe the pump and diaphragm.
• Refer to cleaning instructions «Tubing care and Breastpump
care».
• If necessary clean the pump kit.
• When components are completely dry, reassemble breast-
pump and kit.