Remove Packaging; Grounding The Refrigerator - Sears Kenmore PRO 401.40483800 Instrucciones De Instalación

Ocultar thumbs Ver también para Kenmore PRO 401.40483800:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FLOORING
For proper
installation,
this refrigerator
must be
placed
on a level surface
of hard material
that is
the same height
as the rest of the flooring.
This
surface
should
be strong enough
to support
a
fully loaded
refrigerator,
or approximately
1,500 Ibs.
(680kg).
NOTE:
Protect
the finish of the flooring.
Cut a
large section
of the cardboard
carton
and place
under the refrigerator
where you are working.
GROUNDING
THE REFRIGERATOR
IMPORTANT
m Please
read carefully.
FOR PERSONAL
SAFETY, THIS APPLIANCE
MUST
BE PROPERLY
GROUNDED.
The power
supply
cord of this appliance
is
equipped
with a three-pin
grounding
plug which
mates with a standard
three-pin
grounding
wall
receptacle
to minimize
the possibility
of electric
shock
hazard from this appliance.
Have the wall outlet and circuit
checked
by a
qualified
electrician
to make sure the outlet is
properly
grounded.
Where a standard
2-pin wall outlet
is encountered,
it is your personal
responsibility
and obligation
to
have it replaced
with a properly
grounded
3-pin
wall outlet.
DO NOT, UNDER ANY
CIRCUMSTANCES,
CUT
OR REMOVE THE
THIRD
(GROUNDING)
PIN FROM THE
POWER CORD.
DO NOT USE AN ADAPTER
PLUG TO CONNECT
THE REFRIGERATOR
TO A 2-PIN OUTLET.
DO NOT USE AN EXTENSION
CORD WITH THIS
APPLIANCE.
1. REMOVE
PACKAGING
A CAUTION:
Refrigerator
is Top-Heavy.
Be careful when moving.
When using an appliance
dolly, handle from Freezer side only.
,, Carefully
cut banding
at the top and bottom;
remove
outer carton.
,, Slide out rear corner
posts (2).
,, Slide carton
off top of cabinet.
NOTE:
DO NOT LAY CABINET
DOWN
IN
ORDER
TO REMOVE
SKID!
• The unit is secured to the skid with six 3/8" bolts
and six 1/2" nuts.
Remove all six 3/8" bolts that secure metal
brackets to the refrigerator.
Remove the three 1/2" nuts and washers from the
Freezer side.
Remove nut from rear wood block on Freezer side.
Tilt unit up on Freezer side toward Fresh Food side.
Push bolts down, remove metal bracket from
Freezer side. Remove wood block from Freezer side.
Slide the appliance dolly underneath the Freezer side.
Using corner posts (2 on front corners) to prevent
damage, secure unit to appliance
dolly.
NOTE:
If corner
posts are too long, cut the posts
to a shorter
length.
,, Lift the unit off the skid with the appliance
dolly.
,, Remove
kickplate
taped to the top of the unit.
,, Set kickplate
aside for final installation.
Kickplate Taped
to Top of Unit
1/2"
Nuts
\
CAUTION: DO NOT A TTEMPT
TO
ROLL OR DRAG UNTIL UNIT IS OFF SKID.
4
CAUTION:
MAKE
SURE THE
WATER
LINE IS CLEAR
OF APPLIANCE
DOLLY
TO AVOID
DAMAGE.

Publicidad

Tabla de contenido
loading

Tabla de contenido