Sears Kenmore PRO 401.40483800 Instrucciones De Instalación página 9

9. TURN ON POWER
,, Connect refrigerator power cord plug to a
properly grounded receptacle. Set the Master
Power switch to the I (ON) position.
,, Check to make sure power to refrigerator is
on by opening refrigerator door to see if interior
lights are on.
'£a ii_ _Geril ie
Master Power
Switch
Water
Filter
11. INSTALL KICKPLATE
,, Locate the supplied kickplate (shipped taped to
the top of the refrigerator). Install with 2 screws
provided.
Supplied Kickpiate
NOTE: The vented kickplate must remain
unobstructed for proper air flow.
12. DOOR ALIGNMENT
,, Stand back from the refrigerator to inspect the
door alignment.
,, Shipping may have caused the doors to move
slightly out of alignment.
,, The temperature controls are preset at 38°F (3°C)
for the Fresh Food section and 0°F (-18°C) for the
Freezer section.
,, Allow 24 hours to stabilize before making
adjustments.
10. START ICEMAKER
,, Press the icemaker test button at the upper part
of the freezer compartment for 2 seconds.
,, The ice tray will rotate, then go back to the
original position. The operation is normal when
the rotation is complete and water is provided
for the supply line.
,, Discard the first full bucket of ice cubes.
Set Screw
_ Door Hinge
_ Case Hinge
_¢ Wrench
Raise
Clockwise
Hinge Pin ubber Cap
,, If necessary, refrigerator door may be adjusted up
or down to align with freezer door.
,, Remove rubber cap.
,, Loosen set screw with Phillips screwdriver.
,, Use a 7/32" wrench to adjust hinge pin as shown.
,, Tighten set screw.
,, Replace rubber cap.
NOTE: The addition of food to refrigerator
door bins may require further door alignment
adjustment.