Sears Kenmore PRO 401.40483800 Instrucciones De Instalación página 7

5. CONNECT POWER 7. LEVEL REFRIGERATOR
,, Connect refrigerator power cord plug to a
properly grounded receptacle. Set the
Master Power switch to the I (ON) position.
_o o_1
o o
_se Grille I [_ __
/ I1\
Master Power II ",Water Filter
Switch
11
,, Check to make sure power to refrigerator is on
by opening refrigerator door to see if interior
lights are on.
CAUTION:
After power has been
established, turn the Master Power switch to
the O (OFF) position.
6. MOVE INTO INSTALLATION SPACE
,, Slide unit into the installation space.
,, Place excess slack in power cord on top of the
refrigerator.
,, Use care to ensure that the power cord is not
pinched behind the unit.
i
Height
from Floor
to Anti-Tip
Bracket
82"
All models have 4-point leveling. The front and
back are supported by leveling legs. Both are
accessible from the front of the refrigerator.
,, To level the back of the refrigerator, turn the 1/2"
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower
the refrigerator.
,, For front leveling, use a 7/16" open-end wrench.
,, Adjust height of refrigerator to match installation
cutout opening 83-1/2" to 84-1/2". The
refrigerator should be level and flush with
adjacent cabinets.
Leveling Leg
!
Hex Nut Adjusts
Rear Leveling
Legs
IMPORTANT NOTE: The refrigerator must be level
for proper food storage. After leveling, if refrigerator
door is higher than freezer door, see Step 12 for
Door Alignment.
CAUTION:
The rear leveling legs and
front leveling legs are limited to a maximum height
adjustment of 1 ". If the installation requires more
than 84-1/2" height, the installer should elevate the
refrigerator on a sheet of plywood or runners.
Cabinet trim could be added across the top of the
opening to shorten the opening. If you attempt to
raise the refrigerator more than 1", you will
damage the front and rear leveling legs.