Toro EVOLUTION AG Manual Del Usuario página 27

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Soil Sensor Setup
®
e
EVOLUTION
AG
controller will stop the scheduled watering if the soil sensor is activated.
sensor, halting irrigation when it senses an excessive soil moisture level. You can set the level of soil moisture that will trigger the sensor.
e irrigation schedule will restart after the sensor dries out to the established threshold.
Step 1
– While in the ADVANCED menu, use the Up
Step 2
– Use the Up
or Down
Step 3
– Use the Left
or Right
Step 4
– Use the Up
or Down
rain sensor is activated,
disable the sensor for that schedule.
SENSORS
A
B
RAIN
WEATHER
SOIL 1
SOIL 2
Use the Right
arrow or press SELECT
SENSORS
MOISTURE NOW
LOW THRESHOLD
50%
SIGNAL STRENGTH
BATTERY LEVEL
GOOD
CALIBRATE
START
CAL SETTING
FREEZE OFF AT
39
ID
34278
CURRENT TEMP
70
LOW THRESHOLD - Limit when watering is immediately adjusted.
SIGNAL STRENGTH - Displays the strength of the received signal from the soil sensor.
BATTERY LEVEL - Displays the soil sensor's battery level.
CALIBRATE - Activate to calibrate the soil sensor. Use the Right
Consult the soil sensor's user guide for calibration recommendations.
CAL SETTING - Set a number of times the controller will repeat the calibration and average the measurements.
FREEZE OFF AT - You can set the temperature when the controller will determine freezing and prevents scheduled watering
from operating. Use the Up
ID - Displays the identi cation number of the soil sensor device.
CURRENT TEMP - Displays the current measured soil temperature.
or Down
arrows to select SOIL, then press SELECT
arrows to select the schedule.
arrows to place a check mark under the desired schedules to assign the rain sensor. When the
®
EVOLUTION
AG
will prevent schedules from operating. Replace the check mark with a dash to
Ca
to access the soil sensor setup screen.
5
O
F
O
F
or Down
arrows to adjust the temperature limit to determine the freezing point.
e Soil Sensor works much like a rain
arrows to select SENSORS, then press SELECT
.
arrow to navigate to START, then press SELECT
.
.
23

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido