Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Diagnostics
® AG controller provides a diagnostic function to check whether the system's valves are properly functioning. When
e
EVOLUTION
activated, the controller will test each available valve.
tested. It will display the current level in amps. OVERCRNT will be displayed for valves drawing above the recommended range, SHORT
for valves that have a grounded circuitry, or OPEN if no current is measured.
Since all valve outputs will activate for about 3 seconds during diagnostics, it is recommended that all Fert Pumps (not relays) be
disconnected, or the fertilizer pathway temporarily blocked.
DIAGNOSTICS
VALVE CURRENT TEST
MASTER VALVE
VALVE TEST
VALVE1
VALVE2
VALVE3
Firmware Update
® AG controller can be updated by downloading the latest controller rmware from Toro's
e
EVOLUTION
website, www.toro.com/evolution-ag. Load the rmware onto a USB drive, then insert it into the controller's USB port.
Load New Firmware Version on USB Drive
® AG controller's rmware can easily be updated by downloading the latest software from www.toro.com/evolution-ag.
e
EVOLUTION
A USB ash drive is needed for this procedure.
Note: Although many USB ash drives may function well with the
are recommended:
•
USB Version 2.0 Compliant
•
1–8 GB Memory Size (Smaller memory size will perform faster.)
•
FAT32 File System with 1 Logical Partition
Step 1
– Create a folder inside your USB ash drive with the name Evolution (/Evolution/).
Step 2
– Create a folder inside the Evolution folder with the name Firmware (/Evolution/Firmware/).
– Go to the
EVOLUTION
Step 3
and save the rmware inside the Firmware folder in your USB ash drive.
Update Controller Firmware
Figure 14
U S B
Step 1
– Connect USB to the controller. See Figure 14.
Step 2
– Click the
ADVANCED button. Use the Up
– Select UPDATE and Press SELECT
Step 3
ADVANCED
SCHEDULE DETAILS
SENSORS
ADD/REMOVE DEVICE
DIAGNOSTICS
FIRMWARE
Step 4
– Controller displays the rmware version in the controller (current) and the version on the USB drive (update). If the update
version is more up-to-date than the current version, press SELECT on YES. Firmware le is updated and a status bar will
indicate the progress. Once nished, the controller does a soft reboot and the update process is complete.
ADVANCED
UPDATE VERIFIED
CUR. VERSION
07.14
UPDATE VERSION 07.10
CONTINUE UPDATE
YES
Step 5
– Refer to "Check Firmware Version of Controller" section to verify the rmware version.
® AG controller will display dashes (– –) for valves that have not been
EVOLUTION
0.178
0.180
OPEN
OPEN
® AG website, www.toro.com/evolution-ag, and download the most current rmware version. Unzip
or Down
. Select another UPDATE menu to start the process.
FIRMWARE
CONTROLLER
VERSION
UPDATE
BOOT VERSION:
4.00
REGION
USB DRIVE ATTACHED
LANGUAGE
WRITE: 33%
DATE FORMAT MM/DD/YY
CLOCK
TIME
DATE
BEGIN WEEK
® AG controller, the following USB speci cations
EVOLUTION
arrows to select FIRMWARE.
FIRMWARE
FIRMWARE
UPDATE
VERIFYING UPDATE
33%
SETUP
US/CAN
ENGLISH
12 HOUR
12:01AM
01/01/16
SUNDAY
25
Publicidad
Capítulos
Tabla de contenido
