Operating Instructions - salmson SIE Serie Instalacion Y Puesta En Servicio

Info menu
Service menu
Error acknowledgement menu
Access disable menu
8.6

Operating instructions

8.6.1 Adjusting the setpoint
12.3
Fig. 29: Entering the setpoint
Installation and operating instructions SIE-DIE-PBE
• Settings in service mode should only be made during commission-
• Only acknowledge errors after they have been remedied.
• Allow faults to be remedied by qualified personnel only.
• If in doubt, consult the manufacturer.
1.0.0.0
• Turn the red button.
2200
RPM
• To confirm the change, press the red button.
1.0.0.0
1800
RPM
The main menu <4.0.0.0> and its sub-menu elements show measur-
ing data, device data, operating data and current states.
The main menu <5.0.0.0> and its sub-menu elements provide access
to basic system settings for commissioning. The sub-elements are in
a write-protected mode as long as service mode is not activated.
CAUTION! Risk of property damage!
Improper setting changes can lead to pump operation errors, which
can lead to material damage to the pump or system.
ing and only by qualified personnel.
In the event of an error, the error page is displayed instead of the sta-
tus page. Pressing the red button from this position opens the error
acknowledgement menu (menu number <6.0.0.0>). Any fault signals
present can be acknowledged after a waiting period.
CAUTION! Risk of property damage!
Errors which are acknowledged without their cause having been
remedied can result in repeated faults, which could lead to material
damage to the pump or system.
For additional information, see Chapter 11 "Faults, causes and reme-
dies" on page 97 and the error table shown there.
The main menu <7.0.0.0> is only displayed when DIP switch 2 is in the
ON position. It cannot be reached via normal navigation.
In the "Access disable" menu, the access disable can be activated or
deactivated by turning the red button. The change is confirmed by
pressing the red button.
On the status page of the display, the setpoint can be adjusted as fol-
lows (Fig. 29):
The display changes to menu number <1.0.0.0>. The setpoint begins
to flash and is increased or decreased by continuing to turn.
The new setpoint will be accepted and the display will return to the
status page.
English
79