Electrolysis Cell Life - BSV BS Pool EVOLINK Serie Manual De Usuario

"CL ALARM
"INTERNAL
TEMPERATURE
*"pH ALARM"
"SHORT CIRCUIT"
"OPEN CIRCUIT"
*

4.3- Electrolysis cell life

The electrolysis cells from our units are designed to reach a lifespan of 10.000
hours (10K models) and 5.000 hours (5k models). However, this lifespan is
directly related with the quality of the water and specially with the correct use
of the equipment. Please, read the following suggestions in order to guarantee
that your cell reaches the specified lifespan.
a) Salt concentration:
swimming pool has enough salt concentration, otherwise the cell will
degrade prematurely if you keep it working permanently in low salt
conditions. It is important to add salt when the unit shows the "lack of
salt" indication.
Manual EVOLINK v.5
Free chlorine probe
dirty, worm or
connected
Internal temperature is to
high
Dirty or worm probe
Dossing tank is empty
Dossing mode is selected
wrongly
The cell is incorrectly
connected.
Metal body in the cell.
Cell is incorrectly
connected.
Cell is damaged
completely worn down.
Swimming pool water with
very low
concentration.
It is very important that the water of your
is Check Free
not conditions and clean it
Check where
installed. Make sure there is a
good ventilation on the heat sink
Calibrate probe
conditions
Check if dossing tank is empty
Go to Configuration Menu and
check Dossing mode. ACID will
decrease pH
increase pH level
Check wiring.
Turn off the equipment and
remove the metal body from the
plates
Check the cell connection and
ensure that
connection terminals are in good
condition.
or Check the condition of the cell
electrodes, and replace it if any
damage is observed.
Ensure that the water has salt
salt and that it is dissolved.
Chlorine probe
EVOLINK is
to check its
level. ALK will
cables and
105 / 120