3.3- Electrical wiring diagram
3.3.1- EVOLINK series equipment
Earth connection
L, N:
Supply 220v
SW:
On / Off Switch
PH
pH pump connection (For units with the AUTO kit)
FILTER:
Filter connection for Stop / Start mode
J4:
Terminal block of cell
J8:
1- (yellow) Acid sensor (PH)
2- (yellow) Acid sensor (PH)
3- (purple) Cover
4- (purple) Cover
5- (white) Water sensor (cell's white cable)
6- (white) External flow switch (5-6)*
7- (blue) Temperature probe
* activate the FLOW SWITCH operation in the Configuration Menu
K1: PH Relay
LK2: Stop/Start (see 3.3.2.1)
F1: Fuse
Manual EVOLINK v.5
8- (blue) Temperature probe
9- (brown) ORP-
10- (orange) ORP+
11- (red) 12V free chlorine probe
12- (gray) Conductiviy (GND)
13- (green) Conductivity (signal)
14- (red) Conductivity (12v)
85 / 120