Quick Start; Install Battery - ECOVACS DEEBOT 4 Manual De Instrucciones

3. Operating and Programming

3.2 Quick Start

Charging Dock Placement
1
Place the Charging Dock on a level floor surface
against the wall with the base perpendicular
to the ground. Keep the immediate area 1.5m
(5') in front of the charger and 0.5m (1.6') on
both sides of the charger clear of objects and
reflective surfaces.
Plug the Charging Dock in.
2

Install Battery

Insert the Battery Pack into the battery slot
on the bottom of DEEBOT 4. Press it until it
is fully locked in place.
Remove DEEBOT 4's battery if the robot will not be used for a long time. In case of battery leakage,
*
please remove the battery and wipe the battery slot clean while wearing protective gloves.
If DEEBOT 4's battery is fully discharged or not used for a long time, its capacity may decrease
*
and need to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after charging
*
for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT 4 uses a long life Ni-MH battery and does not require frequent replacement. To
*
replace the battery, contact Customer Service or follow the below instructions:
a. Push the tabs on both sides of the Battery Pack to remove the Battery Pack.
b. Insert new Battery Pack and press until it's fully locked in place.
3 Install Side Brushes
Attach Side Brushes to the bottom of
DEEBOT 4 by pressing a brush into each slot
until it clicks.
8
EN