Cleaning Of The Squeegee; Disassembly Of The Rotating Brushes - COMAC OMNIA 26 Manual De Uso

CLEANING OF THE SQUEEGEE

CLEANING OF THE SQUEEGEE
CLEANING OF THE SQUEEGEE CLEANING OF THE SQUEEGEE
In order to have the best drying results, check that the squeegee is always clean. To
clean the squeegee:
1. Lift the squeegee through the suitable lever
2. Clean accurately the inside of the squeegee with a water jet
3. Clean accurately the squeegee rubbers with a water jet
4. Check the rubber wear and if necessary, turn them upside-down or change them
Note The careful cleaning of the complete suction group assures higher life of the Note Note Note
suction motor.

DISASSEMBLY OF THE ROTATING BRUSHES

DISASSEMBLY OF THE ROTATING BRUSHES DISASSEMBLY OF THE ROTATING BRUSHES DISASSEMBLY OF THE ROTATING BRUSHES
1. Lift the brushes base acting upon the suitable handle
Note In case of machines with automatic control (machines with actuator), lift the Note
Note Note
brushes base acting upon the suitable lever button.
2. Rotate the key into position OFF and take if off from the switch
ATTENTION! To carry out the operations of the rotary brushes' ATTENTION! ATTENTION! ATTENTION!
disassembly with connected current can cause serious damages to
the hands.
3. Unhook the splash guard rubbers of the brushes base (for the disassembly of the
splash guard rubbers see "REPLACEMENT SPLASH GUARD BRUSHES BASE")
4. Rotate the brush until it comes off from the brush plate seat as shown in the figure.
The figure shows the rotating direction of the brushes disassembly.
DAILY MAINTENANCE DAILY MAINTENANCE
DAILY MAINTENANCE DAILY MAINTENANCE
45