Weekly Maintenance; Replacement Rear Squeegee Rubber; Replacement Front Squeegee Rubber; Replacement Splash Guard Brushes Base - COMAC OMNIA 26 Manual De Uso

REPLACEMENT REAR SQUEEGEE RUBBER

REPLACEMENT REAR SQUEEGEE RUBBER REPLACEMENT REAR SQUEEGEE RUBBER REPLACEMENT REAR SQUEEGEE RUBBER
If the rear squeegee rubber is worn and does not dry well, it is possible to change the
drying edge proceeding as follows:
1. Push and rotate the fixing plates (1)
2. Slip off the rubber blade and the rubber itself
3. Turn the rubber upside-down and if necessary, replace it
4. Reassemble everything repeating inversely above operations
5. Adjust the squeegee height depending on the rubber (see under "SQUEEGEE
ADJUSTMENT")

REPLACEMENT FRONT SQUEEGEE RUBBER

REPLACEMENT FRONT SQUEEGEE RUBBER REPLACEMENT FRONT SQUEEGEE RUBBER REPLACEMENT FRONT SQUEEGEE RUBBER
Aspiration is poor and the machine will not dry perfectly if the front floor-wiper rubber is
worn. Proceed as follows to replace:
1. Detach the floor-wiper from the machine (1)
2. Loosen the screws that clamp the front rubber
3. Pull out the rubber-pressing blade
4. Pull out and replace the rubber
Reassemble by repeating these procedures in reverse order

REPLACEMENT SPLASH GUARD BRUSHES BASE

REPLACEMENT SPLASH GUARD BRUSHES BASE REPLACEMENT SPLASH GUARD BRUSHES BASE REPLACEMENT SPLASH GUARD BRUSHES BASE
Check the condition of the splash guards brushes base. If necessary, to replace them,
proceed as follows:
1. Loosen the screws (1) which fix the metallic blades
2. Take off the splash guard and replace it
3. Reassemble everything repeating inversely above operations

WEEKLY MAINTENANCE

WEEKLY MAINTENANCE
WEEKLY MAINTENANCE WEEKLY MAINTENANCE
46
1