Satcr Function - Promax US TV EXPLORER II Manual De Uso

When selecting the COMMANDS option in the Spectrum Analyzer mode
[13] it will appear on the screen a dynamic execution line in order to use with the
positioned commands: DRIVE EAST / WEST. This allows carrying out a fine adjustment
in steps or in seconds to aim the antenna through the rotary selector
70
60
50
40
DRIVE EAST (STEPS)
CH:
Press the DiSEqC key
execution mode and to locate the mark cursor on the frequency or channel.
5.21

SATCR function

By means of SatCR function it is possible to control the devices of a TV
installation satellite that are compatible with the SatCR
Router), which allows concentrating manifold down frequencies (slots) by an only cable.
By this way each user using a slot can tune and decode any signal present in the
satellite.
In order to select the SatCR function, press the DiSEqC key
panel, and using the rotary selector
are the configuration options that users can modify: slot selection, number of slots,
device address, frequency step, pilot signal activation, and finally the frequencies
corresponding to each slot.
10
SatCR is a trademark of STMicroelectronics.
Page 80
FREQ.:
POWER:
12108.1
Figure 60.- DiSEqC commands: DRIVE.
[21] on the front panel in order to quit the commands
[1] activate the SATCR option. In the display
USER'S MANUAL. US TV EXPLORER
1508.80 MHz
64.4 dB
5
SPAN: 200 MHz
10
technology (Satellite Channel
II
[1].
[21] from frontal
11/2013