Coffee Preparation; Steam Outlet; Getting Hot Wate; Machine Stop - Bezzera BZ07 DE Manual De Instrucciones

5.3 Coffee Preparation

1) Remove the filter holder (Fig.01; pos. 6) from
the supply group (Fig. 01; pos. 5).
2) Put the ground coffee into the filter holder,
press it and make attention that the filter hol-
der edge is not dirty with coffee.
3) Replace the filter holder in its housing.
Version PM
4) Press the coffee supply key (Fig. 04; pos.a).
5) Press again the above key to stop the coffee
supply.
Version DE
4) Press one of the keys of the coffee distribu-
tion keypad (Fig. 05) according to the desi-
red dose.
Follow the instructions of paragraph 5.7 of this
booklet in order to change the doseprogram-
ming.The machine is preset for the continuous
distribution: press the key " " (Fig. 05; pos. c)
to start the distribution, press it again to stop it.
Caution:
- Do not remove the filter holder filled with cof-
fee when the equipment is operatingbecause
it is under preassure.
- Do not touch expressly the metal plating of
the filter holder; danger of burns.

5.4 Steam Outlet

(Fig. 06)
1) In order to avoid eddies in the boiler, let off
steam by pressing the relevant knob (7).
2) Insert the nozzle (Fig. 01; pos. 9) into the
container with the fluid to be heated.
3) Press and keep pressed the steam knob (7).
The outlet steam depends on the knob opening:
the more the knob is opened, the more the
steam is let off.
4) After the steam has been blown off, let off
the knob , take out the container and clean
immediately the nozzle with a damp cloth in
order to remove residual heated water.
Caution: Do not touch expressly the steam
nozzle; danger of burns
5.5 Getting Hot Water
1) Place the water container under the dispen-
ser (Fig. 01; pos. 8).
2) Press and keep pressed the knob (Fig. 01;
pos. 7) to get the required quantity of water.
3) After the water has been blown off, let off
the knob.
Caution: Do not touch expressly the water di-
spenser; danger of burns

5.6 Machine Stop

1) Turn off the water knob (Fig. 01; pos. 1).
2) Press the switch (Fig. 01; pos. 2) and verify
if the green led is off.
5.7 Dose Programming (version
DE)
(Fig.05)
a = single dose
b = double dose
c = continuous dispensing
To program every single dose, do what follows:
keep pressed the key " " relatived to the con-
tinuous dose programming (Fig. 05; pos. c) for
about 5 seconds until the LED blinks.
Select the desired dose by pressing the relati-ve
key (a-b) (LED switching-on), select thekey once
again after reaching the desired dose (LED
switching-off); the dose is programmed.
Notes:
- The push-button panel LEDs blink intermitten-
tly: no water into the tank.
- The push-button panel LEDs blink intermitten-
tly and quickly: no water into the boiler.
- The LED of the button selected blinks: too fine
coffee.
N.B.
If the water should not come out of the group
(Fig. 01; pos. 5) although the boiler is under-
pressure and there is water into the tank, turn
off the switch (Fig. 01; pos. 1) and releasethe
vapour from the tap (Fig.01; pos. 9). Wait for
the machine to cool completely.
21
BEZZERA BZ07
MOD.