Reverting The Instrument To Factory Settings (System Reset) - Hioki FT6380 Manual De Instrucciones

54
2.6 Advanced Settings and Functions
To disable APS temporarily
Turn on the instrument by pressing the
while holding down the
the next time the instrument's power is cycled. The next
time the power is cycled, APS will be enabled (as long
as the APS setting is enabled in sub-function mode).
Reverting the instrument to factory settings
(system reset)
This section describes how to initialize the instrument's settings.
All measurement data (up to 2,000 values) will be deleted.
1.
Enter sub-function mode.
Press the POWER
2.
Using the
and press the
3.
Press the OK
tory settings.
• If the System Reset screen is displayed by mistake,
cycle the instrument's power without pressing the
key. Instrument operation will be restored without a
system reset having been performed.
• For more information about how to clear previously saved
measurement data, see "Clearing stored data (p.40)".
key while holding down the
▼ ▲
and keys, select the System Reset screen
OK key. The
key again. The instrument will revert to the fac-
HOLD key to disable APS until
[OK?] mark will flash.
POWER key
Fn key.
OK