Ottobock 2C7 Instrucciones De Uso página 16

NOTICE
Grinding the footshell
Premature wear resulting from damage to the footshell
► Do not grind the footshell.
► Inform the patient.
5.1 Installing the footshell
Tools required:
>
Vice, 704G30 clamping tool, 2C101 footshell replacement tool, flat
screwdriver, T10 Torx screwdriver (see fig. 4 –
1) NOTICE! Proceed carefully during installation.
Do not damage the spacer lug
replacement tool (see fig. 2).
2) Insert a flat screwdriver into the groove
out of the cover cap
3) Unscrew the screws
4) Remove the cover cap
5) NOTICE! Do not damage the plug connection and cable. Do not
pull on the cable.
Pull the plug
(see fig. 5).
6) NOTICE! To protect the pyramid adapter, use the 704G30 clamping
tool.
Clamp the clamping tool
7) Mount the pyramid adapter of the prosthetic foot in the pyramid receiver
of the clamping tool.
8) Pull off the old footshell, if any, according to the section "Removing the
footshell" (see Page 17).
9) Bring the prosthetic foot to maximum plantar flexion (see the instructions
for use of the prosthetic foot).
10) Fold the spacer lug
11) Slide the footshell
12) Insert the tool
13) NOTICE! Do not excessively deform the footshell while pulling it
on. Do not puncture the folds in the footshell with the tool.
Pull the posterior edge
(see fig. 8).
14) Engage the sole
15) Engage the spacer lug
16
(see fig. 3).
(see fig. 4).
.
of the cable out of the receptacle
into the vice
in the proximal direction (see fig. 7).
as far as possible onto the prosthetic foot
into the footshell along the sole
of the footshell over the sole with the tool
in the adapter
in the adapter
)
and cables
and push the cover plate
(see fig. 6).
.
of the footshell (see fig. 9).
of the footshell.
with the footshell
in the cover cap
.