Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso página 57

_MS-800.book Seite 57 Donnerstag, 1. Juni 2006 8:22 08
MagicSpeed MS800
Caution
Before you drill holes, make sure the bit will not damage anything
on the other side (2, page 4).
➤ Select a suitable installation location (5, page 5).
➤ Mark the holes for installation.
➤ Drill two 3 mm holes.
➤ Temporarily mount the electronic module at the selected position.
Do not fasten the electronic module before you have decided where to
lay the cables.
➤ After finishing assembly, fasten the module to the selected position:
Screw the electronic module securely to the vehicle with the screws
supplied or use double-sided adhesive tape.
6.3 Installing the interface module
When selecting the installation location, observe the following
instructions:
Install the interface module
– In the driver's area
– As close as possible to the accelerator pedal
– Not anywhere subject to heat or moisture
– Not in the engine compartment
– Not near high-voltage components
– Not directly at ventilator nozzles.
Where possible use existing holes in the vehicle.
Caution
Before you drill holes, make sure the bit will not damage anything
on the other side (2, page 4).
➤ Select a suitable installation location (5, page 5).
➤ Mark the holes for installation.
➤ Drill two 3 mm holes.
Installing MagicSpeed
57