Using Magicspeed - Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso

_MS-800.book Seite 79 Donnerstag, 1. Juni 2006 8:22 08
MagicSpeed MS800
12

Using MagicSpeed

Operate MagicSpeed using the buttons on the control element.
ON/OFF button
➤ Press the ON/OFF button once to switch on the speed regulator.
✓ The LED on the control element lights up.
➤ When the speed regulator is switched on, press the ON/OFF button once
to switch it off.
✓ The LED on the control element goes off.
SET button
Use the SET button to save the speed you want on the speed regulator.
➤ Press the SET button and let go again immediately to set the speed you
are currently driving.
This set speed is maintained until:
– You press the brake or clutch pedal
– You switch off the device with the ON/OFF button
– The car slows down to below the lower activation speed
– The speed drops on a slope by more than 25 %.
➤ Press and hold down the SET button to accelerate the car.
When you let go of the SET button the speed regulator records the
current speed and saves it.
RES button
Press the RES button to recall the last saved speed when:
You have switched on the speed regulator using the ON/OFF button
You do not press the brake or clutch pedal
You do not switch off the ignition in the meantime
The car does not slow down to below the lower activation speed
The current speed is not less than 50 % of the saved value.
➤ Press the RES button and let go again immediately to recall the last saved
speed.
Using MagicSpeed
79