Starting Automatic Mode - Waeco MagicSpeed MS800 Instrucciones De Montaje Y De Uso

_MS-800.book Seite 73 Donnerstag, 1. Juni 2006 8:22 08
MagicSpeed MS800
10.1 Starting setup mode
Note
To begin one of the three adjusting and teach modes you must
always start the following procedure.
This is how to start setup mode:
➤ Start the engine.
➤ Press the ON/OFF button on the control module.
➤ Apply the brake within one minute and hold it down.
➤ Press the setup button four times in succession.
✓ You will hear four audible signals.
✓ You are now in setup mode and can adjust the speed regulator.
10.2 Quitting setup mode
This is how to quit setup mode:
➤ Stop the car.
➤ Apply the brake and hold it down.
➤ Press the SET button four times.
✓ You will hear a long, high-pitched signal.
10.3

Starting automatic mode

In automatic mode, the PPM, INIT and GAIN parameters are automatically
adjusted to your car. You can still fine-tune these parameters at any time.
➤ Start setup mode (chapter "Starting setup mode" on page 73).
➤ To start automatic mode, apply the brake and hold it down.
➤ Press the RES button once.
✓ An low-pitched acoustic signal sounds.
➤ Release the brake.
✓ An high-pitched acoustic signal sounds.
Setting and teaching MagicSpeed
73