Jotul I 570 Manual De Uso página 32

ENGLISH
Table of contents
Installation manual with technical data
1.0 Regulatory information .................................. 32
2.0 Technical data ................................................. 32
3.0 Installation ..................................................... 34
4.0 Servicing .......................................................... 38
5.0 Optional Equipment ....................................... 38
General use and maintenance manual
6.0 Safety precautions
7.0 Choice of fuel
8.0 Use
9.0 Maintenance
10.0 Operational problems - troubleshooting
On all our products there is a label
Product:
Jøtul
indicating the serial number and
Room heater fired by solid fuel
year. Write this number in the
Standard :
Minimum distance to adjacent combustible materials:
Minimum distance to adjacent combustible materials:
place indicated in the installation
Emission of CO in combustion products :
Flue gas temperature :
Nominal heat output
:
instructions.
Efficiency :
Operation range
:
Fuel type :
Operational type :
The appliance can be used in a shared flue.
Always quote this serial number when
Country Classification Certificate/ Approved by
standard
contacting your retailer or Jøtul.
Norway Klasse II
SP Sveriges Provnings- och
SP
Sweden
OGC
Forskningsinstitut AB
SP Swedish National
Testing and Research
EUR Intermittent EN
Institute
Follow user`s instructions. Use only recommended fuels.
Montage- und Bedienungsanleitung beachten.
Verwenden Sie nur empfohlenen Brennstoffen.
Respectez les consignes d'utilisation. Utilisez uniquement
les combustibles recommandés.
Serial no: Y-xxxx, Year: 200x
Manufacturer: 221546
Jøtul AS
POB 1441
N-1602 Fredrikstad
Norway
32
Serial no.
1.0 Regulatory information
Installation of a fireplace must be according to local codes and
regulations in each country.
All local regulations, including those that refer to national and
European standards, shall be complied with when installing
the product.
Both an installation manual with technical data and a general
user and maintenance manual accompany the product. The
installation can only be taken into use after it has been checked
by a qualified inspector.
An approval label made of heat resistant material is located
on the heat shield at the back of the product. This contains
information about identification and documentation for the
product.
2.0 Technical data
Material:
Finish:
Fuel:
Log length, max.:
Flue outlet:
Flue dimension
(outside the outlet) :
Approx. weight:
Optional extras:
Dimensions, distances etc.: See fig.1
Technical data according to EN 13229
Nominal heat output:
Smoke gas mass flow:
Recommended chimney draught: 12 Pa
Effiency:
CO emission (13% O ):
2
Flue gas temperature:
Operating mode:
Wood consumption
The efficiency of Jøtul I 570 gives it a nominal heat output of 14,0
kW. Wood consumption, at nominal heat output: Approx. 4,0
kg/h. The size of the pieces of wood should be:
Kindling (finely split wood):
Length: approx. 30 cm
Diameter: 2-5 cm
Quantity required each time: 6 - 8 pieces
Wood (split wood):
Recommended length: 30 - 50 cm
Diameter: Approx. 12 - 15 cm
Interval for adding wood: Approx. every 65 minutes
Fire size: 4,3 kg (nominal output)
Quantity required each time: 4 pieces
Nominal heat output is achieved when the ignition vent is
approx. 30 % open (fig.12 B) and the air vent is 60% (fig. 12 A).
Cast iron
Black paint
Wood
55 cm
Top
Ø 200 mm/314 cm 2 cross section
220 kg
Decorative frame, internal ash
solution
14,0 kW
13,2 g/s
77%@14,0 kW
0,12 %
0
265 C
Continuous