Jotul I 570 Manual De Uso página 36

ENGLISH
Attaching the legs and securing the base
heat shield
Fig. 4
4. Dismount the insert's heat shield by unscrewing the upper
screw on both sides of the insert (fig. 4 A). Loosen the lower
screws (fig. 4 E) somewhat and pull the heat shield upwards
and then remove it.
5. Lay the insert carefully down on its back (you can protect the
floor with the wooden pallet and cardboard packaging).
Fig. 5
6. Assemble the 4 legs (fig. 5 A) with the 4 adjustable joints (fig.
5 C) using the 4 screws and nuts that are in a bag in the box.
Fig. 6
7. Then attach these to the insert using the four (B) M6 x 25
mm countersunk screws (B) and washers. The screws and
washers are already attached to the base of the insert. Turn
the adjustable joints to obtain the required height.
36
8. Stand the burn chamber up.
9. Make final adjustments to the legs once the insert has been
test-mounted.
Fig. 7
10. The bracket (fig. 7 A) should be placed under the screw heads
to protect the surface and to prevent the insert from slipping
out of place. Make final adjustments using the M10 x 45 mm
screws (fig. 7 B) attached to the joints.
Fig. 8
11. Position the heat shield on the insert's adjustable joints (fig. 8 A).
12. Refit all the parts that were removed for easier handling of
the insert.
13. Reposition the previously removed heat shield (see step 4).