Installation Instructions - Mi-T-M HLP Serie Instrucciones De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

danGer
risK of eXplosion or fire!
do not place unit in an
area WHere flammable
Gas Vapors may be present.
a sparK could cause an
eXplosion or fire!
risK of unit burstinG!
do not locate tHe unit in
freeZinG enVironments!
WarninG
risK of aspHyXiation!
use tHis product only in
Well Ventilated areas! tHe
eXHaust contains carbon
monoXide, a poisonous,
odorless and inVisible
Gas.
breatHinG tHis Gas
can cause serious inJury,
illness & possible deatH.
2

installation instructions

set-up:
. This unit should only be placed on a level surface to ensure proper lubrication
of the water pump during operation. NEVER spray water directly on the
unit.
2. This unit must be placed in an area away from flammable or combustible
material. These types of materials must be kept at least 20 feet from the
unit.
3. Do not use this unit in an area where any of the following conditions are
present:
a. Flammable gas vapors
b. Insufficient ventilation
c. Evidence of oil or fuel leaks
4. Do not allow this unit to be exposed to rain, snow, or freezing temperatures.
If any part of the unit becomes frozen, excessive pressure may build up in
the unit which could cause it to burst resulting in possible serious injury to
the operator or bystanders.
5. Pump oil level should be checked before each use. Make certain the oil
is on the full mark on the dipstick. If the level is low, fill with SAE20 or 30
non-detergent pump oil.
HLP-SERIES Hot Water Pressure Washer Operator's Manual

Publicidad

Tabla de contenido
loading

Tabla de contenido