Lamp Adjustment; Inserting/Exchanging Gobos - Futurelight PHS-1200E Pro-Head-Spot Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lamp adjustment

the center, or if light output is low, the lamp is too far back in the reflector. "Push" the lamp out by turning the
screws „1, 2, 3" counterclockwise ¼-turn at a time the light is bright and evenly distributed.

Inserting/Exchanging gobos

If you wish to use other forms and patterns as the standard-gobos, or if gobos are to be exchanged, please
follow the instructions below:
Remove the fixation-ring with an appropriate tool. Remove the gobo and insert the new gobo. Press the
fixation-ring together and insert it in front of the gobo.
DANGER!
Install the gobos with the device switched off only.
Unplug from mains before!
CAUTION!
Never unscrew the screws of the rotating gobo
as the ball bearing will otherwise be opened!
The lampholder is aligned at the factory. Due to
differences between lamps, fine adjustment may
improve light performance.
Strike the lamp, open the shutter, set the dimmer
intensity onto 100 % and direct the light towards
a flat surface (wall). Center the hot-spot (the
brightest part of the beam) using the 3
adjustment screws „1, 2, 3" Turn one screw at a
time to drag the hot-spot diagonally across the
projected image. If you cannot detect a hot-spot,
adjust the lamp until the light is even.
To reduce a hot-spot, pull the lamp in by turning
all three screws „1, 2, 3" clockwise ¼-turn at a
time until the light is evenly distributed.
If the light is brighter around the edge than it is in
44/130
00026924.DOC; Version 1.6

Publicidad

Tabla de contenido
loading

Tabla de contenido