Futurelight PHS-1200E Pro-Head-Spot Manual Del Usuario página 62

Edit scenes
With this function, you can edit the scenes of the internal programs.
Auto scenes rec
The device features an integrated DMX-recorder by which you can transmit the programmed scenes from
your DMX-controller to the device. Adjust the desired scene numbers via the encoder (from – to). When you
call up the scenes at your controller, they will automatically be transmitted to the device.
Excursion:
A Master unit can send up to 3 different data groups to the Slave units, i.e. a Master unit can start 3 different
Slave units, which run 3 different programs. The Master unit sends the 3 program parts in a continuous loop.
The Slave unit receives data from the Master unit according to the group which the Slave unit was assigned
to. If e.g. a Slave unit is set to „Slave 1" in the menu „Set to Slave", the Master unit sends „Auto Program
Part 1" to the Slave unit. If set to „Slave 2", the Slave unit receives „Auto Program Part 2".
To start a Auto Program please proceed as follows:
1.Slave-Setting
• Select "Function Mode" by turning the encoder.
• Press the Enter button to confirm.
• Select "Set to slave" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Slave 1", "Slave 2" or "Slave 3".
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
2. Automatic Program Run
• Select "Function Mode" by turning the encoder.
• Press the Enter button to confirm.
• Select "Auto Program" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Master" or "Alone". The selection "Alone" means Stand Alone-mode and
"Master" that the device is defined as master.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
3. Program selection for Auto Pro Part
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Select "Select programs" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select "Auto Pro Part 1", "Auto Pro Part 2" or "Auto Pro Part 3", and thus select
which Slave program is to be sent. Selection „Part 1" means, that the Slave unit runs the same program as
the master units.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
4. Program selection for Edit Program
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Select "Edit program" by turning the encoder.
• Press the Enter button to confirm.
• Turn the encoder to select the desired program. With this function you can edit specific scenes into a
specific program.
• Press the Enter button to confirm.
• Press the Mode/Esc button in order to return to the main menu.
62/130 00026924.DOC; Version 1.6