Installation And Start-Up - Cebora SYNSTAR TWIN 270 T Manual De Instrucciones

3 CONTROLS LOCATED ON FRONT PANEL.
E
Art.
344
SYNSTAR TWIN SYNSTAR TWIN
C
TORCH TORCH
®
A – DISPLAY SCREEN.
This displays both the welding parameters and all the
welding functions.
C – CENTRAL ADAPTER :
Connect the welding torch
C1 – CENTRAL ADAPTER.
This is where the welding torch or the Push-Pull system
torch is to be connected.
D – SOCKET (-): this is where the earth cable is to be
connected.
E– CONNECTOR : For connecting remote controls and
the welding control cable Push–Pull Art.
12
ZONA NON ADESIVA
ZONA
TRASPARENTE
PUSH PULL PUSH PULL
TORCH TORCH
270 T
4 CONTROLS LOCATED ON REAR PANEL.
A
B
H
C1
D
G – MAIN CABLE
F– SWITCH.
Starts and stops the machine
H – GAS PIPE CONNECTIONS.

5 INSTALLATION AND START-UP

Position the welding machine so as to allow the free cir-
culation of air inside and, as much as possible, prevent
metal or other dusts from penetrating. Position the weld-
ing machine in an area that ensures good stability.The
weight of the welding machine is approximately 68 Kg.
Only skilled personnel should install the machine.All con-
nections must be carried out in compliance with current
standards (IEC/CEI EN 60974-9) and in full observance
of current safety laws.Make sure that the supply voltage
corresponds to the rated voltage of the welding machine.
Size the protective fuses based on the data listed on the
technical specifications plate. Mount the plug on the pow-
er cord, being especially carefully to connect the yellow/
green conductor to the earth pole. This welding machine
has been designed to contemporarily mount 2 welding
torches and 2 coils of wire having one a diameter of MAX
300 mm and the other one of MAX 200 mm .
This power source cannot weld with the 2 torches at
the same time, the choice of wich torch and type of
metal to weld is made simply by pressing and releas-
ing for a few moments the start button of any of the
two torches.
F
G
H