Adjusting The Recline Position - CYBEX gold CLOUD Q Manual Del Propietário

USING THE INFANT CARRIER
7. Pull up on Harness Straps to snug around the child's
hips while holding the Harness Buckle in place.
8. Slowly pull the adjuster strap to tighten the Shoulder Straps.
A snug strap should not allow any slack. It lies in a relatively
straight line without sagging. It does not press on the child's
flesh or push the child's body into an unnatural position.
9. Position the center of the Chest Clip even with the
child's armpits. Make sure the Shoulder Pads do not
interfere with the placement of the Chest Clip.
If the Shoulder Pads don't allow a proper fit,they can be removed to
provide more space for the Chest Clip. Unsnap to remove.
10. Harness Pinch Test. To test for a properly tightened
Harness, pinch the shoulder strap. A snug Harness
should not allow you to pinch any slack when pinched
between your thumb and forefinger. If needed, pull
adjuster strap further for a tight and proper fit.
To keep child warm, place a blanket over child and Infant Carrier, AFTER
you have properly secured and tightened Harness around your child.
ALWAYS KEEP child properly secured in Harness.
NEVER SECURE child in Infant Carrier dressed in a
bulky garment or heavy clothing.
21
7
8
9
10
USING THE INFANT CARRIER OUTSIDE OF THE VEHICLE

ADJUSTING THE RECLINE POSITION

A new function of the Cloud Q is that it can be reclined to an almost
horizontal position outside of the car. With an extended leg-rest
and a fully reclined backrest, the child can lie comfortably and in an
ergonomically correct position.
The recline angle can be adjusted easily with one hand without
having to take the child out of the carrier, and the handle remains in
the carrying position for easier mobility.
1. While holding one hand on the handle, simply squeeze
the Recline Release Handle and push the seatback
down until it locks into the full recline position.
In the reclined position a red blocker closes off the lap belt
guide to indicate that it is not allowed to use the carrier in a
vehicle when the carrier is reclined.
2. To get back to Car Seat Mode simply squeeze
the Recline Release Handle and lift backrest
up until it locks into the upright position.
Combined with the CYBEX Priam and M-strollers the Cloud Q
becomes a both striking and very practical travel system.
The CYBEX CLOUD Q must only be reclined outside of
the vehicle.
NEVER INSTALL this child restraint in a vehicle when
the carrier is in the reclined position.
1 RECLINED MODE
2
CAR SEAT MODE
22