Adjust Recline; Adjusting The Recline Angle Without The Base - CYBEX gold CLOUD Q Manual Del Propietário

ADJUSTING THE RECLINE ANGLE WITHOUT THE BASE

It's very important for your child's safety that this child
restraint be installed at the correct angle.
DO NOT use this or any other child restraint with a
premature, low birth weight, or medically fragile infant,
until after you have consulted with your doctor. Some
infants may have difficulty breathing or have other
medical problems when placed in a seated position.
If the child restraint is too upright, the child's head
may fall forward and cause breathing problems. If the
child restraint is TOO RECLINED crash protection will
be reduced.
Failure to properly recline the child restraint on the
vehicle seat increases the risk of Death or serious
injury.

ADJUST RECLINE

Adjust the seat angle until the RED Level Line on the Infant
Carrier is level with the ground.
If you are having trouble achieving the proper recline angle:
1. Uninstall Infant Carrier.
2. Place a tightly rolled towel or pool noodle under
the Infant Carrier, where indicated. If on an aircraft,
a tightly rolled airline blanket may be placed
under the Infant Carrier to adjust the angle.
3. Continue installation.
45
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
USING THE INFANT CARRIER ON AIRPLANE
The FAA recommends that children up to 40 pounds
(18 kg) use a certified, harnessed child seat while travelling
on an airplane. The Cloud Q is certified for airplane use.
INSTALLING THE CARRIER ON AIRPLANE
Install your Infant Carrier in a window seat to avoid blocking the aisle.
1. Position Infant Carrier rear facing in aircraft seat with the
foot end firmly against the back of the aircraft seat.
2. Route lap belt under both Belt Guides. BUCKLE THE BELT.
3. Push Infant Carrier firmly into aircraft seat
while removing slack from the lap belt.
4. Check the recline angle. Adjust the seat angle until the red
Level Line on the Infant Carrier is level with the floor of the
aircraft. A tightly rolled airline blanket may be placed under
the Infant Carrier to adjust the angle. See page 45.
5. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it is
installed correctly. The Infant Carrier should not move
more than 1 inch (2.5 cm) in any direction.
6. As a final step, unfasten the chest clip. In order to comply with
the FAA regulation for Portable Electronic Devices (PED), the
SensorSafe Chest Clip MUST be unfastened before take-off.
Note: After landing, fasten the SensorSafe Chest Clip
before removing the Infant Car Seat from Aircraft seat.
If the Infant Carrier moves too much, tighten the airplane belts more and
recheck. If you plan to use the Base at your destination, don't forget to
gate check the Base or check it in as luggage.
DO NOT USE the Base on airplane.
ALWAYS have the handle locked in the DRIVE position
while using this child restraint on aircraft.
NEVER use the L.S.P. device on airplane.
NEVER recline back rest when using carrier in airplane.
1
3
CLICK!
2
(aircraft)
FRONT OF VEHICLE
4
(aircraft floor)
LINE MUST BE LEVEL WITH GROUND
WHEN INSTALLED WITHOUT BASE
FRONT OF VEHICLE
LINE MUST BE LEVEL WITH GROUND
46