Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Operating + Maintenance (O + M) Instruction manual
Axial TGT, THGT fans,
Axial TGT ATEX, fans.
This manual applies to axial fans for use in ventilation, emergency smoke ventilation and for use in
A potentially explosive atmosphere (ATEX) is a serious hazard to life, health and safety - strict attention to risk prevention must
be applied by all persons. In Europe ATEX Directive 1994 / 9 / EC applies to products, and Directive 1999 / 92 / EC applies to
worker protection.
This instruction manual contains important information and must be read carefully by competent persons prior to any handling, transport,
inspection or installation of this product. Every care has been taken in the preparation of the instructions and information, however, it is
the responsibility of the installer to ensure the system complies with relevant national and international regulations, especially safety. This
document refers to direct drive axial fans. Further guidance is contained in the specific motor manufactures manual, where applicable,
supplied with the product.
The manufacturer; Soler & Palau Sistemas de Ventilación S.L.U. accepts no responsibility for costs, breakages, accidents or any
inconvenience caused by failure to comply with the instructions contained in this manual.
The fans referred to in this manual have been manufactured in accordance with rigorous quality control and International standard ISO
9001.
Contents:
1.1 Warnings
1.3 Transport
1
1.1 Warnings
This manual provides information and instructions for the correct lifting, installation, use and maintenance of the fans listed. For
characteristics specific to each model, see the respective product catalogue, selection data sheet. The instructions and recommendations
contained in this manual are general to the differing fan models in the range produced by Soler & Palau.
The purchaser, Installer, user is responsible for ensuring that the fan is installed, operated and serviced by qualified personnel, acting in
accordance with all safety precautions applicable and as required by law, regulations and standards in the country applicable.
Further instructions for correct use may be found in the relevant product catalogues and selection data.
A specific application that requires increased safety awareness applies to:-
ATEX Fans, which, according to European Directive 1994/9/EC, are designed and restricted to use in the:
specific application applicable,
Equipment Group and Category applicable,
Explosion Group for gases and vapours applicable, or
Gas or Dust type applicable,
Temperature class applicable.
The user/employer/competent body is responsible for ATEX risk analysis. Fan equipment is determined by this ATEX risk. Refer IEC
EN 60079-14 Electrical installations in hazardous areas (other than mines) especially Section 5.
Fan equipment Name plate/Label includes ATEX specification applicable, Fan serial number, Fan type, motor data, year of
manufacture, and where applicable, grease information, CE mark, and any corresponding documentation.
Any other use, application or installation requiring a superior specification to fan equipment is prohibited.
S&P do not manufacture ATEX fan equipment for Equipment Group I: Mines.
S&P do not manufacture ATEX fan equipment for Equipment Group II: Surface Industry, Equipment Category 1G, or 1D or 2D (Zone
0, or 20 or 21)
All fans are designed and manufactured in accordance with EC Machinery Directive 2006/42/EC. Safety guard accessories are available
from S&P if required due to specific installation.
26
ATEX areas.
Publicidad
Capítulos
