WARNING: Never pour water into the cooker body or immerse it in water. Always
ensure the inner cooking pot is completely dry before placing it back in the cooker
body.
6.
Clean the plastic rim of the cooker body with a damp cloth. Avoid getting water
inside of the cooker body.
Occasionally
1.
Remove the air vent/cover lock for cleaning. Place your finger over the air vent/
cover lock hole in the top of the cover (Fig. below) and remove the gasket from
the underside of the cover (Fig. below). Push the air vent/cover lock through the
top of the cover. Wash it and the gasket in warm, soapy water. The metal shaft may
be cleaned with a nylon mesh pad. Clean the cover hole with a small brush. After
cleaning, reinsert the metal shaft from the top side of the cover down through the
cover hole. Place a finger over the hole and push the gasket onto the end of the
metal shaft until it snaps into the groove.
2.
Wipe the outside of the cooker body with a damp cloth.
NOTE: Do not place the lid in a dishwasher. Hand wash only.
Air vent cover
MAINTENANCE
•
Store the product in a cool, dry place.
•
Never cut anything in the cookware or use utensils with sharp edges as to avoid
piercing the non-stick surface.
•
Never put cold water into a hot cooking pot. Sudden changes of temperature may
cause metal to warp, resulting in an uneven bottom. Let cookware cool down on
its own or place in lukewarm soapy water.
•
Always use trivets or oven mitts when handling the pot.
•
DO NOT place the cooking pot on countertop, as it will stain or burn the
countertop. Use a protective trivet.
•
DO NOT place the pot on any range top burner, under a broiler, microwave
browning element, or in a heated oven.
•
DO NOT strike utensils against rim of pot to dislodge food, as it will scratch it.
•
DO NOT use metal utensils with this appliance. Use the provided rice measure (or
recommended utensil) to prevent chipping of the cooking pot.
•
DO NOT use scouring pads, abrasive cleaners, or any object that will scratch the
cookware or accessories.
•
Any other servicing should be performed by an authorized service representative.
22
Gasket