Changing The Contact Points; Fitting The Collar - Num'axes IKI PULSE Manual De Instrucciones

CAUTION: if the protection tab is badly repositioned or badly engaged, the waterproofness of your collar will be compromised
and you are likely to damage your product.
Minimum Sensitivity
protection tab
Checking/reloading battery
When the indicator light flashes in red when switching On or Off the collar, it indicates that the battery is too weak for the
operation of the product.
The product switches to safety mode, it is out of use.
It is necessary to recharge the battery (See § Charge of the product).
A full charge takes approximately 3 hours.

Changing the contact points

Two different series of contact points are included in the package. The length of the contact points must be sufficient to have
proper contact with the dog's skin, enabling the device to operate correctly.
If you have a long haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace
them with the long ones supplied with the kit.
When changing the contact points, do not use a key for tightening or untightening them because it could damage some
components.
A moderate manual screwing is sufficient.

Fitting the collar

The strap should be adjusted so that the contact points come right into contact with the dog's skin in order to ensure good
barking detection.
- If the strap is too loose, the collar will not operate properly. Moreover, it might move around the dog's neck and repeated
rubbing of the contact points on the skin can cause irritation.
- If the strap is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
Maximum Sensitivity
Medium Sensitivity
Gb - 16