Publicidad
①
②
④
⑤
12
English
③
TO INSTALL SHIELD
Place complete shield assembly (the pivot cover and base plate pre-installed on
the shield) on the helmet so that the two screw holes on both sides are over the
threaded screw receptacles ①.
Push the shield down until the latch post fully engages the shield and the latch
lever captures the bottom of the shield ②.
Install the two screws through the pivot cover on each side into the helmet,
leaving them slightly snug, do not fully tighten yet ③.
Push on the front of the shield to bring it fully home against the eye-port trim.
While still pushing on the shield to keep it tight against the helmet, fully snug
down the screws, but do not over tighten. It may be necessary to do one side at
a time with a smoothing pressure from the shield center toward each base plate
and tightening each in turn for best results ④.
Work the shield up and down to confirm proper operation ⑤.
Publicidad
Capítulos
