Descargar Imprimir esta página

Arai Helmet CONCEPT-X Instrucciones De Uso página 6

Publicidad

6
English
WARNING :
If your shield becomes too scratched or uncleanable, replace it with a new one.
Impaired visibility causes accidents.
Use a solution of mild soap or detergent and lukewarm water to clean your shield.
Rinse well with clean water, and wipe off with a soft cloth. Never use petrol,
thinner, benzene or any other solvents. There are many "aggressive" cleaners
on the market, including some supposed to be specifically for use on shield. Arai
strongly recommends that you do not use any such products to clean your shield
as some of their ingredients may have damaging effects on the shield and other
plastic parts installed on your helmet.
Do not apply stickers or adhesive tape to the shield, as this will weaken the hard
coating. If tinted, the shield is for daylight use only.
TO OPERATE DEMIST SYSTEM
A demist function is incorporated in the shield latch system to allow more rapid
clearing of any interior mist with the shield remaining partially latched. Push
the shield latch lever up to release shield into the demist position to assist
moisture dispersal
. To close the shield completely, push the shield down
until the latch post fully engages the shield and latch lever captures the bottom
of the shield
.
TO OPERATE BROWVENTS
The Browvents are operated from fully closed through intermediate, to fully open
positions by simply pulling the vent control down to open, pushing up to close.

Publicidad

loading

Este manual también es adecuado para:

Concept-rapide