Dispensing Steam; Autosteamer (Optional) - Astoria Core600 Serie Manual De Uso

Dispensing steam

6.7
• Immerse the steam nozzle in the
liquid to be heated;
• rotate the tap knob anti-clock-
wise;
• the quantity of steam will be
proportional to the opening of
the tap;
• to end dispensing, rotate the tap
knob clockwise.
For optimal foaming, it is recom-
mended to observe the following
simple rules:
• Only heat the amount of milk that
you intend to use; once heated, it
will have to be completely poured
out of the jug and cannot be re-
heated;
• foam the milk starting from a
temperature of about 4 °C.
Carefully handle the steam spout through
the specific scald-preventing rubber grip
(1).
Avoid contact with the steam nozzles, do
not direct your hands or other body parts
towards the steam nozzle ends.
To keep the terminals of the steam spouts perfectly efficient, it is
suggested to carry out a short empty dispensing at the end of
every work session. Keep the tips clean at all times using a cloth
dampened in lukewarm water.
The use of the steam dispensing point
(steam nozzle), must always be preceded
by condensation draining for at least 2
seconds.
Leave the steam nozzle immersed in the
milk only for the heating time required.
Do not open the steam tap with the steam
spout immersed in milk while the machine
is off.
USER manual

Autosteamer (optional)

6.8
• Immerse the steam wand nozzle
into the milk;
• select the
• wait until the dispensing process
is complete. As an indication that
the set temperature has been
reached, the
also change;
• to stop dispensing ahead of time,
press the
The temperature of the beverage
will always be shown on the display.
Select the
has been reached to dispense steam for an additional 10
seconds (function available up to
a maximum temperature of 80°C),
or switch it off by pressing and
holding down the first button for
10 seconds.
1
Avoid contact with the steam nozzle, do not place your hands or
other body parts near the steam wand nozzle tips.
Keep the tips clean at all times using a cloth dampened in
lukewarm water. To keep the steam wand nozzle tips in perfect
working order, perform a brief dry dispensing run after each use.
When programmed, 5 minutes after the steam wand was last used
2 sound alerts will go off and a few seconds later, the machine will
automatically clean the steam wand using 5 short spurts of steam.
To change the temperature of the steam wand, see para.
MILK
"7.2.6 Cup warmer temperature" on page 68.
button;
button will
key again.
64°C
Temperature
Autosteamer
button after the set temperature
61 288
of